Every fall, the clocks change and every fire department in the country says the same thing: change your batteries. They say it because it works, and because almost nobody does it until the chirp starts at 3 a.m. Here is the other reason to do it this weekend. When a buyer’s inspector walks your house, the alarms and the outlets near water are among the first things he checks, because they are fast to test and they matter. A dead alarm is a two-minute fix for you. On an inspection report it is a line item that makes the whole house look less cared for.
The rule for today: test and replace, don’t rewire. Pressing buttons and swapping batteries is a homeowner job. Anything behind a cover plate or inside the panel belongs to a licensed electrician.
1. Smoke Alarms: Test, Then Read the Date
🚨 Press the Button, Then Flip It Over
Press the test button on every alarm and listen for a loud, full sound. Then twist one off the ceiling and read the manufacture date on the back. Most manufacturers say to replace a smoke alarm about every 10 years, whatever the battery says. Check that there is one on each level and near the bedrooms.
Cheap now: a new battery, or a new alarm for the price of a pizza. Expensive later: an inspection note on every alarm in the house, and a seller who looks like they never checked.
2. Carbon Monoxide Alarms: Do You Even Have One?
⚠ The One People Forget
If you heat with gas, burn wood in a fireplace, or have an attached garage, you want a CO alarm near the sleeping areas and on each level. These have a shelf life too, usually five to ten years, printed on the unit. Test the button and check the date, the same as the smoke alarms.
Requirements for these vary by jurisdiction, so ask your local fire department what applies to your address. We would rather you over-protect the house than argue over a rule.
3. The Outlets Near Water
💦 Press TEST on Every GFCI
Walk the kitchen, bathrooms, laundry, garage and the outdoor outlets. Where you see an outlet with TEST and RESET buttons, press TEST. The power should click off. Press RESET and it should come back. If it will not trip, will not reset, or feels loose or warm, stop and call an electrician. Do not just live with it.
While you are there, look for cracked cover plates and outlets that are loose in the wall. A new cover plate is a couple of dollars. A loose outlet is the sort of thing that gets written up.
4. A Look at the Panel (Look Only)
🔌 Labels, Rust and Anything That Smells Hot
Open the panel door, nothing more, and take a photo. Are the breakers labeled? Do you see rust, water stains, scorch marks, or a breaker that has been tripped for who knows how long? Do not remove the inner cover, and do not touch the wires.
Labeling the breakers is a free Sunday job that makes you look organized. Anything in there that looks burned, wet or wrong is an electrician’s call, and a good reason to make it before you list.
Why This One Is Worth the Half Hour
Safety items are the easiest repair requests for a buyer to make and the hardest for a seller to argue with. Nobody wants to haggle over a smoke alarm. Handle the small stuff now and the negotiation is about the house, not the checklist.
None of this replaces a licensed electrician or your local fire department’s guidance, and it is not a way around disclosure. If you know of a real electrical problem, you disclose it. This is about catching the cheap things while they are cheap.
✅ Print This: The Fall-Back Safety Walk
- Test every smoke alarm and check the date on the back
- Confirm there is a CO alarm near the bedrooms and on each level, and test it
- Press TEST and RESET on every GFCI outlet in the kitchen, baths, laundry, garage and outdoors
- Look at cover plates for cracks and outlets for looseness
- Open the panel door only, label the breakers, and photograph anything that looks off
🏠 Thinking About Listing This Winter or Spring?
Send us your address and we’ll tell you what your house is worth today and what, if anything, is worth fixing before it hits the market — and what isn’t. We run sales, mortgage and title under one roof, so we see every inspection that comes through.
Safety Walk FAQ
How often should I replace smoke alarms?
Where do carbon monoxide alarms go?
What is a GFCI outlet and how do I test it?
Can I replace a breaker or outlet myself?
📱 Got a Question About Your House? Text Greg.
Not sure whether something you found is worth fixing? Text Greg Holthaus directly — just tell him you saw his blog. He’ll give you a straight answer, match you with the right broker, and tell you honestly if the answer is “don’t worry about it.”
Text Greg · 618.925.8654About this post: General homeowner guidance based on 25+ years of listing and closing homes across Southern Illinois. It is not a home inspection, not electrical, fire-safety, plumbing, roofing or structural advice, and not a statement of what any inspector, lender or code official will require — those vary by property and jurisdiction. Hire licensed professionals for roofing, electrical, plumbing, structural and gas work, and follow your local fire department’s guidance on alarms. Nothing here replaces the Illinois Residential Real Property Disclosure Report or your obligation to disclose known defects, and nothing here is a guarantee of sale price, closing date, or outcome. Want a specific read on your house? Ask us for a Comparative Market Analysis.
